Hi-Velocity Systems Explained The Hi-Velocity Cooling System does not make or break any existing laws of how cooling is normally done; it just uses those laws differently than a conventional low velocity system. With a conventional low velocity forced air-cooling system, the rule that everyone knows is “400 CFM per ton”. With 400 CFM at a low static pressure, and a large face area / thin depth coil, the air is cooled, and a small amount of humidity is removed. This is the only way that cooling can work, right? Wrong! (Read more ...) Application Options In the Applications article you will find information on Heating (Hot Water, Heat Pumps & Electric), Cooling (Refrigerant, Chilled Water, & Heat Pump) IAQ Indoor Air Quality (Filtration, Ventilation & Humidification) (Read more ...) Case Study of Potable Water Heating on the Fancoil System With the escalating cost of natural gas today, you can no longer allow your old gas fired furnace to needlessly "Blow your money out the chimney" Energy Saving Products manufactures the Lo-Velocity Heat System (Lo-V).The Lo-V system is a flameless furnace that conveniently replaces your old natural gas furnace. you can realize a saving of up to 50% in your gas bill. (Amount of savings to consumer depends on inefficiency of old furnace). The major bonus is in the improvement in the home environment. The "New Aire" will be comfortably moist and evenly warmed. Environmentally sensitive people (Asthmatics/Allergenic) immediately appreciate the improvement in Lo-V Aire. A three year comprehensive study and comparison was conduted by Dave Bykowsky, V.P. Research & Development of Energy Saving Products Ltd. The results are outlined in the balance of this report This report is a case study summary of Natural gas consumption for the typical family of four in an 1100 square foot bungalow. (Read more ...) User Guide In the User Guide article you will find how the system can provide heating, cooling, filtration, ventilation and humidification. It will also explain the sequence of operation, timer chip, maintenance, and the systems efficiency/performance. (Read more ...) Hi-Velocity Printed Circuit Board In recognition of concerns expressed by Plumbing Inspection Departments, Engineers, Home Builders, Home Owners, and Installing Contractors, Energy Saving Products Ltd. offers a timer processor which is installed on our standard printed circuit board. This allows water from an approved dual purpose water heater to be circulated for a five minute period every 24 hours. (Read more ...) Bernoulli’s Theorem While Energy Saving Products has not been providing quality home comfort systems for the last 300 years, without the basic principles developed by great minds of the times, we would still be in the heating & cooling dark ages. We will go back to Feb 8, 1700 in Groningen, Netherlands with the birth of Daniel Bernoulli. As well we will look at The Venturi Effect: Back to 1746 and look at Giovanni Venturi, a professor of physics at the universities of Modena and Pavia. Then onto Inventing the Hi-Velocity Systems : We will go back to 1920 and Calvin MacCracken, an inventor without peer. (Read more ...) Thermo Expansion Valves The Thermo Expansion Valve is a precision device designed to regulate the rate of refrigerant liquid flow into the evaporator in the exact proportion to the rate of evaporation of the refrigerant liquid in the evaporator. (Part One ...) (Part Two ...) (Part Three ...) Winter is Here! Are you ready for it? Now is the time to ensure that your heating system is working well (Read more ...)